The things i add here are primarily for my reference, but they could save you a lot of time, so here i am only covering the practical side, wikipedia can help you with the theory. things here are sort of in random order, so feel free to use your browser’s search facility.
I have the following positioning systems/chips/boards, so most of the stuff you will find here will relate to them
* V.KEL VK2828U7G5LF TTL Ublox GPS module with antenna: supports GPS, GALILEO, SBAS (WAAS, EGNOS, MSAS, GAGAN)
* K-172 USB GPS USB Receiver Dongle Adapter Smart Antenna Module For Gmouse Glonass, also running u-blox, Support NMEA 0183 and ublox binary protocol.
* The ADAFRUIT ultimate breakout board with the MTK3339 chip (Not U-BLOX), but rather mediatek
A-GPS and AssistNow:
The long story short: A-GPS seems to be when the satellite data is available in advance, whether you allow your system to download it from the internet as it goes, or you download it in advance and make it available to the system, it boils down to telling your system where the satellites are and their relevant data rather than wait for your device to download that data from the satellites at very low speeds (Sat data is downloaded at a maximum of 50 bits per second, so getting the data over the internet or from the SD card in your raspberry pi or arduino etc is much much faster).
AssistNow is how the U-Blox A-GPS works
1- A-GPS only work out of the box with u-center, the software by u-blox, on your raspberry PI or arduino, it will not work out of the box , to make it work you need to look online for software that does that (It’s on github)
the online edition is when the data is downloaded from the internet in real time (when it is needed), the AssistNow offline is when you download “AlmanacPlus® Differential Almanac Correction Data” from the internet and store it with your device (On whatever is driving the device, be it a PC, laptop, raspberry pi, arduino etc…)
2- The adafruit GPS raspberry pi board does A-GPS in a different way, which works out of the box, they add a battery to the board, and once data is downloaded once, it stays on the board for as long as there is a battery 😉
One thought on “GPS / u-blox and Adafruit-Mediatek”
This is a good, lightweight, fast, and inexpensive GPS. I prefer to use the TinyGPS++ library by Mikal Hart but the original one works well too. If you have not used a GPS before, you just need , ground, and a serial port to receive data and there are plenty of tutorials on how to use the TinyGPS library to turn the data into something useful